What size drill bit did you use for the ordinance bays?
It was a pin vice that matched the paperclip size. Don't know exactly off hand.
did you also use a pin vice for the larger magnet holes?
No, it was a power drill. I believe the magnets were around 3/16 inch.
What size drill bit did you use for the ordinance bays?
ReplyDeleteIt was a pin vice that matched the paperclip size. Don't know exactly off hand.
ReplyDeletedid you also use a pin vice for the larger magnet holes?
DeleteNo, it was a power drill. I believe the magnets were around 3/16 inch.
Delete